Champion-power-equipment 90720 Manuel d'utilisateur télécharger pdf (Page 11)

REV 90720-20131010 8

90720 ENGLISH

ASSEMBLY

Your log splitter requires some assembly.

If you have any questions regarding the assembly of your

log splitter, call our help line at 1-877-338-0999. Please

have your serial number and model number available.

Open Shipping Crate

1. Set the shipping crate on a solid, ﬂat surface

2. Carefully cut the shipping bands and remove lid of

shipping crate.

3. Locate all hardware before beginning assembly.

1) Install the Wheels to the Wheel Mount

1. Slide the wheel onto the wheel mount.

2. Slide washer (#38) and snap ring (#39) onto the

wheel mount bolt.

3. Repeat steps 1 and 2 for other wheel

2) Install the Support Foot

1. Align the Support Foot with the mounting holes

under the beam

2. Place the bolt through the hole

3. Place a washer and lock washer on the end of the

bolt.

4. Install the nut on the bolt and tighten. Do not over

tighten.

3) Install the Beam onto the Wheel Mount

1. Align the 4 threaded blocks on the back of the beam over

the 4 larger holes on the side of the wheel mount.

2. Thread an M10x20 bolt (#34) through a M10 washer

(#22).

3. Thread the bolt and washer under the wheel mount up into

the small blocks on the back of the beam and tighten.

4. Repeat steps 1-3 for the remaining 3 bolt and washer sets

to complete the mounting of the beam to the wheel mount.

4) Install the Engine to the Wheel Mount

1. Align the 4 holes on the base of the engine with the

4 smaller holes on the wheel mount.

2. Thread an M8x20 bolt (#36) through an M8 lock

washer (#26) and M8 washer (#27).

3. Thread a bolt and washers set through a hole on the

bottom of the wheel mount into the engine and tighten.

4. Repeat steps 1-3 for the remaining 3 bolt and

washer sets to complete mounting of the engine to

the wheel mount.

The snap ring requires snap ring pilers (O.D.).

Available at hardware and auto part stores.

NOTE

The beam should extend to the opposite side of the

wheel mounts as shown.

NOTE

The recoil side of the engine should point the same

direction as the beam as shown.

NOTE

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 29 30

Commentaires sur ces manuels

Pas de commentaire

Champion-power-equipment 90720 Manuel d'utilisateur Page 11

Commentaires sur ces manuels