Champion Power Equipment PP-3 Manuel d'utilisateur télécharger pdf (Page 20)

CONTROL PANELS

Timer Operation

The change water timer (t) will retain its current count when the washer is stopped or when

power has been disconnected from the controller.

The soap delay timer (t2) allows for a delay before soap is dispensed into the wash tank.

This will allow the soap to be added to a wash tank when it is full of water and the

circulation pumps are running.

The soap dispensing timer (τ3) determines the time for soap dispensing. A time of 0.00 will

bypass the soap dispensing process.

Keypad Operation

Used to decrement or modify a parameter value, or to show the software version when in configuration/calibration mode.

Used to increment or modify a parameter value, or to show the heater sheath temperature

Used to scroll the display to the next parameter and to store a modified parameter value

Used to cycle the circulation pumps and to restart the washer after a change water cycle has been completed

Used to decrement or modify a parameter value, or to show the software version when in configuration/calibration mode.

Used to bypass the change water status, this resets the change water timer and advances the controller

to the fil state.

Note

: Buttons must be pressed in the order shown, and held for roughly 15 seconds.

Used to enable / disable the dis

lay lam

test.

OTE

Buttons must be pressed in the order shown.

Used to access the supervisor mode.

NOTE

: Buttons must be pressed in the order shown, and held for roughly 3 seconds.

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 66 67

Pas de commentaire

Champion Power Equipment PP-3 Manuel d'utilisateur Page 20