Champion Power Equipment PP-3 Manuel d'utilisateur télécharger pdf (Page 31)

CONTROL PANELS

The cycle LED will light up and the first setting STEP1 DURATION will scroll on the

display, and alternate every 5 seconds with its value.

Use the UP and DOWN keys to adjust a setting. Once the wanted value is displayed,

pressing the OFF key again will bring up the next setting. Change all settings for as many

steps as required (up to 3 per Cycle). If step duration is set to 0, then all following

parameters are ignored and the unit returns to the previous mode. It is assumed that

programming for this particular cycle is finished.

Note that in all setting descriptions below, X can be 1 , 2 , or 3 , depending on the current

step being programmed.

Step Duration

This is the time that the unit will remain in the current step. If there is only 1 step defined

for the cycle, this also corresponds to the total cycle time. If a step has 0 duration, the

current step and all following ones are not programmable (i.e. not used). If step 1 is set to 0,

then the cycle is not defined and pressing the Cycle key will not do anything.

Setting name: STEP X DURATION

Allowed values: 0:00 to 9.59

Default value: 1:00

Step Temperature

The wash tank’s water temperature is defined here.

Setting name: STEP X TEMPERATURE

Allowed values: 100˚ f to 125˚ f (38˚ c to 52˚ c)

Default value: 115˚ f (46˚ c)

Step Pump Speed

This is the pump speed during the particular step.

Setting name: STEP X PUMP SPEED

Allowed values: LOW, MED, or HIGH

Default value: LOW

1 2 ... 26 27 28 29 30 31 32 33 34 35 36 ... 66 67

Pas de commentaire

Champion Power Equipment PP-3 Manuel d'utilisateur Page 31